| Slant Six Forum https://www.slantsix.org/forum/ |
|
| 8 1/4 rear question https://www.slantsix.org/forum/viewtopic.php?t=27047 |
Page 1 of 1 |
| Author: | Brian [ Thu Feb 07, 2008 5:21 am ] |
| Post subject: | 8 1/4 rear question |
Do all 8 1/4 ring and pinion sets interchange between housings? Say 1973-1995. What about the truck rearends? I remember having a problem trying to put a 8 1/4 sure grip with 4.10 gears into a 1974 A body housing. It just would not set up right no matter what I tried. I took the same unit and installed it in a 1979 F body housing with no problems. I just had to change the carrier bearings. It just seems like 8 1/4 truck ring & pinions are turning up everywhere really cheap. Just wondering why. |
|
| Author: | 66aCUDA [ Thu Feb 07, 2008 7:47 am ] |
| Post subject: | |
Brian There was some discussion on the 276 geared 8 1/4 as not being compatable with any other gear sets. I think that was Joshie 225's thread. Im following this close as 8 3/4 are hard to find here. Frank |
|
| Author: | Brian [ Thu Feb 07, 2008 10:13 am ] |
| Post subject: | |
I think that was only for the 2.45 carrier. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|