Post on all the different Mopar boards in the PARTS WANTED section.
Frank
| Slant Six Forum https://www.slantsix.org/forum/ |
|
| 7 1/4 question https://www.slantsix.org/forum/viewtopic.php?t=27715 |
Page 1 of 1 |
| Author: | volare320hp [ Sat Mar 08, 2008 6:25 pm ] |
| Post subject: | 7 1/4 question |
where can i get a sure grip setup for a 7 1/4. I have not opened mine but i pretty sure its not right now. The car is a 1977 Plymouth Volare with a 225/6 one bbl carb. Any help would be nice b/c i want to set it up for drag this year. |
|
| Author: | 66aCUDA [ Sat Mar 08, 2008 6:34 pm ] |
| Post subject: | |
Post on all the different Mopar boards in the PARTS WANTED section. Frank |
|
| Author: | derranged-gadgeteer [ Tue Mar 11, 2008 7:50 pm ] |
| Post subject: | |
if you're going to drag race it, you can take and weld the spider gears in the differential together, make yourself a spool. But then it would be a bitch to drive. |
|
| Author: | dank10fenny [ Tue Mar 11, 2008 8:02 pm ] |
| Post subject: | |
plus if you weld in the diff your axle and side gears are gone for further use, they might break too. thats why a real spool is nice, you can take it out and not modify your needed parts |
|
| Author: | Old6rodder [ Tue Mar 11, 2008 11:49 pm ] |
| Post subject: | |
Here's one. And possibly another. |
|
| Author: | volare320hp [ Fri Mar 21, 2008 10:53 pm ] |
| Post subject: | where do i get one |
Where do i get a spool. I haven't been able to find one. I would use one from another rear end if i could find one to fit. Any help would be grateful. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|