Slant Six Forum :: Mounting Degree Wheel

:
: That is the best way to do it. Although you
: could get away with drilling the center and
: using a crank bolt with a rubber washer. The
: 3 bolt method is the best.
: I degreed in my Comp Cams 252S Saturday, and
: found that the Cloyes Double Roller chain
: and sprockets I purchased from NAPA had
: mismarked "dots" stamped on them.
: After the initial degreeing I had to run
: over to my friends and drill press my cam
: gear and use the Mopar Bushing set I got
: (used the 4 degree bushing) to get it within
: spec.
:
: -D.Idiot

Author:	Brent [ Sun Oct 21, 2001 9:36 pm ]
Post subject:	Mounting Degree Wheel
What is the best way of mounting a 7" Mr. Gasket degree wheel on a Slant 6 and any comments on competition cams 264 camshaft would be appreciated. Thank you. lauchlin@shaw.ca

Author:	CrAlt [ Mon Oct 22, 2001 8:15 am ]
Post subject:	Re: Mounting Degree Wheel PIC
Quote: : What is the best way of mounting a 7" Mr. : Gasket degree wheel on a Slant 6 and any : comments on competition cams 264 camshaft : would be appreciated. Thank you. See <A HREF="http://hackme.dhs.org">http://hackme.dhs.org</A>:8080/pics/degree/ I took pics of mine mounted. from the side cralt@hackme.dhs.org

Author:	DusterIdiot [ Mon Oct 22, 2001 12:46 pm ]
Post subject:	Re: Mounting Degree Wheel
That is the best way to do it. Although you could get away with drilling the center and using a crank bolt with a rubber washer. The 3 bolt method is the best. I degreed in my Comp Cams 252S Saturday, and found that the Cloyes Double Roller chain and sprockets I purchased from NAPA had mismarked "dots" stamped on them. After the initial degreeing I had to run over to my friends and drill press my cam gear and use the Mopar Bushing set I got (used the 4 degree bushing) to get it within spec. -D.Idiot res0aus2@verizon.net

Author:	Charlie Schmid [ Mon Oct 22, 2001 8:22 pm ]
Post subject:	Re: Mounting Degree Wheel
D.I. Do you have a part number for the NAPA/Cloyes chain and sprocket set? Charlie Quote: : : That is the best way to do it. Although you : could get away with drilling the center and : using a crank bolt with a rubber washer. The : 3 bolt method is the best. : I degreed in my Comp Cams 252S Saturday, and : found that the Cloyes Double Roller chain : and sprockets I purchased from NAPA had : mismarked "dots" stamped on them. : After the initial degreeing I had to run : over to my friends and drill press my cam : gear and use the Mopar Bushing set I got : (used the 4 degree bushing) to get it within : spec. : : -D.Idiot flturbo6@aol.com

Slant Six Forum https://www.slantsix.org/forum/

Mounting Degree Wheel https://www.slantsix.org/forum/viewtopic.php?t=2792	Page 1 of 1

Page 1 of 1	All times are UTC-08:00
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/