| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Holley 1920/1945 Snout Measurement https://www.slantsix.org/forum/viewtopic.php?t=28179 |
Page 1 of 1 |
| Author: | 65Dodge100 [ Tue Apr 01, 2008 11:27 pm ] |
| Post subject: | Holley 1920/1945 Snout Measurement |
Does anyone know the outside diameter of the snout, or part of the carburetor that the breather fits on, on a Holley 1920/1945? Thanks, Danny |
|
| Author: | R66GT [ Wed Apr 02, 2008 12:34 am ] |
| Post subject: | |
I have a 1920 sitting on the shelf at home. If no one has posted by then, I will measure it for you when I get home in the morning. |
|
| Author: | R66GT [ Wed Apr 02, 2008 8:10 am ] |
| Post subject: | |
2 and 1/4 inches. Hope it helps. |
|
| Author: | SlantSixDan [ Wed Apr 02, 2008 8:55 am ] |
| Post subject: | |
Officially, 2-1/8" (The small-block and slant-6 2bbls are 2-5/8"). And the "breather" is the ~3" diameter device atop the valve cover that keeps liquid oil out of the intake tract. You mean the part of the carburetor where the air cleaner fits. |
|
| Author: | 65Dodge100 [ Wed Apr 02, 2008 11:59 am ] |
| Post subject: | |
Thanks guys. That helps a bunch. |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|