| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Shaved head cc's https://www.slantsix.org/forum/viewtopic.php?t=2842 |
Page 1 of 1 |
| Author: | Tom [ Tue Nov 06, 2001 8:16 pm ] |
| Post subject: | Shaved head cc's |
Just wondering if anyone has cut a head .100 and cc'd it. I haven't measured mine yet, but was curious what kind of numbers people had gotten. Also, is there much difference in combustion chamber size for different years? Thanks, Tom sschultz@telusplanet.net |
|
| Author: | Dart270 [ Tue Nov 06, 2001 8:19 pm ] |
| Post subject: | Re: Shaved head cc's |
Quote:
: Just wondering if anyone has cut a head .100 : and cc'd it. I haven't measured mine yet, : but was curious what kind of numbers people : had gotten. Also, is there much difference : in combustion chamber size for different : years? : Thanks, Tom I haven't done 0.100", but based on other heads I've done, I'd say the cc's should work out around 41-44. Lou |
|
| Author: | Will [ Wed Nov 07, 2001 12:19 am ] |
| Post subject: | Re: Shaved head cc's |
It depends on the type of valve and how deep they are seated in the head. I think mine is 56 cc. I can look it up if it is that inportant. Will Quote:
: Just wondering if anyone has cut a head .100 : and cc'd it. I haven't measured mine yet, : but was curious what kind of numbers people : had gotten. Also, is there much difference : in combustion chamber size for different : years? : Thanks, Tom slantsix@netzero.net |
|
| Author: | Doctor Dodge (Doug Dutra) [ Wed Nov 07, 2001 10:47 pm ] |
| Post subject: | Re: Milled SL6 head cc's |
Quote:
: Just wondering if anyone has cut a head .100 : and cc'd it. I haven't measured mine yet, : but was curious what kind of numbers people : had gotten. Also, is there much difference : in combustion chamber size for different : years? : Thanks, Tom All the SL6 heads are about the same chamber size which is called-out at 54 CCs, In "real life" they run a bit more then that. (55 to as much as 60) I feel that a lot of the difference is based on the type of valve used. (dished vs flat face and how deep the seat is) The last SL6 head I milled .100 and put large "flat faced" O/S valves into, ended-up at 39 CCs. ( I kept the valves up high in the chamber for the best flow ) DD More Info. on SL6 Head Milling & CCs |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|