If it's an A-body 4 speed the shaft should be the same length, but you will have to swap yokes.
| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Drive-shaft lengths the same? https://www.slantsix.org/forum/viewtopic.php?t=28680 |
Page 1 of 1 |
| Author: | b5cuda [ Wed Apr 30, 2008 9:47 am ] |
| Post subject: | Drive-shaft lengths the same? |
Hey all, I'm getting ready to swap in an 833OD in place of my 904 trans. Just wondering whether the drive-shaft length is the same or do I need to resize it? Car is a '69 Barracuda with 318, 8.75 rearend. Thanks! Bill Hillsboro, OR |
|
| Author: | slantzilla [ Wed Apr 30, 2008 10:13 am ] |
| Post subject: | |
If it's an A-body 4 speed the shaft should be the same length, but you will have to swap yokes.
|
|
| Author: | b5cuda [ Wed Apr 30, 2008 10:42 am ] |
| Post subject: | |
Yes it is an a-body 833OD, I knew about the yoke but wasn't sure on the drive-shaft length. Thanks for the good news! |
|
| Author: | mopar_nocar [ Thu May 01, 2008 1:46 pm ] |
| Post subject: | |
I assume the same would be true for the F-body tranny as well? sb |
|
| Author: | DusterIdiot [ Thu May 01, 2008 3:02 pm ] |
| Post subject: | Yep... |
Quote: I assume the same would be true for the F-body tranny as well?
Yes, the A and F body A-833OD are the same... -D.Idiot |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|