Head milling

Unanswered topics | Active topics

Home » Board index » Tech Q & A » Engine

All times are UTC-08:00

Post new topic Reply to topic

Page 1 of 1

[ 3 posts ]

Print view

Previous topic | Next topic

Author

Message

Dart74

Post subject: Head milling

PostPosted: Tue May 20, 2008 2:22 pm

Offline

4 BBL ''Hyper-Pak''

Joined: Fri Nov 30, 2007 2:02 pm
Posts: 39
Car Model:

Hi! IÂ´ve got a quick question for you; what is the "deck" height from the valves to the gasket surfae on a 225 mec.lifter head? (1974). Planning to mill this head but IÂ´m not sure if it has been done before. IÂ´ll cc the chambers but still interested in how much has been removed...

Thanks,
Rob

_________________
Rob,
Dart -74 4dht.

Top

Profile

Reply with quote

Doc

Post subject:

PostPosted: Tue May 20, 2008 3:36 pm

Offline

Guru

Joined: Mon Oct 14, 2002 4:32 pm
Posts: 4880
Location: Working in Silicon Valley, USA
Car Model:

Measure the over-all thickness of the head, uncut ones tend to be a little over 3.600 thick.
It is more important to know the cc's of the chambers.
Review this thread for more info.
DD

Top

Profile

Reply with quote

Dart74

Post subject:

PostPosted: Wed May 21, 2008 9:17 am

Offline

4 BBL ''Hyper-Pak''

Joined: Fri Nov 30, 2007 2:02 pm
Posts: 39
Car Model:

Thanks Doc, I was looking for that thread but guess my search-skills could be better

_________________
Rob,
Dart -74 4dht.

Top

Profile

Reply with quote

Post new topic Reply to topic

Page 1 of 1

[ 3 posts ]

Home » Board index » Tech Q & A » Engine

All times are UTC-08:00

Who is online

Users browsing this forum: Ahrefs [Bot], Google [Bot] and 14 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum