Thanks Doc, I was looking for that thread but guess my search-skills could be better
| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Head milling https://www.slantsix.org/forum/viewtopic.php?t=29056 |
Page 1 of 1 |
| Author: | Dart74 [ Tue May 20, 2008 2:22 pm ] |
| Post subject: | Head milling |
Hi! I´ve got a quick question for you; what is the "deck" height from the valves to the gasket surfae on a 225 mec.lifter head? (1974). Planning to mill this head but I´m not sure if it has been done before. I´ll cc the chambers but still interested in how much has been removed... Thanks, Rob |
|
| Author: | Doc [ Tue May 20, 2008 3:36 pm ] |
| Post subject: | |
Measure the over-all thickness of the head, uncut ones tend to be a little over 3.600 thick. It is more important to know the cc's of the chambers. Review this thread for more info. DD |
|
| Author: | Dart74 [ Wed May 21, 2008 9:17 am ] |
| Post subject: | |
Thanks Doc, I was looking for that thread but guess my search-skills could be better
|
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|