Is there a template or guide out there for porting the slant six head? I've done a pretty decent gasket matching job, but I don't know where to go from there.

Also, is there anything to be done porting wise for an Offenhauser 4 bbl intake?

_________________
Stephan Nelle

just make sure to get the 'burrs' out of the ports, shave some off the valve guide area, unless you are running O/S valves and high compression.... you won't need to do too much to the head for improvements on the street....

-D.idiot

The head is in the shop right now getting o/s valves and has been milled .100 What else can I do to the head noting those modifications?

_________________
Stephan Nelle

Hey Pinkiedog,

How much did they charge you for the whole job (oversized valves, seats, and milling)?

-Mac