| Slant Six Forum https://www.slantsix.org/forum/ |
|
| 1 Barrel sizes? https://www.slantsix.org/forum/viewtopic.php?t=29292 |
Page 1 of 1 |
| Author: | MichaelS [ Tue Jun 03, 2008 9:53 am ] |
| Post subject: | 1 Barrel sizes? |
What is the largest CFM 1 barrel that will fit the stock manifold? |
|
| Author: | SlantSixDan [ Tue Jun 03, 2008 11:21 am ] |
| Post subject: | |
The slant-6 used an SAE-standard carburetor mounting flange, so your question's pretty wide open. Is there something particular you're trying to accomplish? |
|
| Author: | MichaelS [ Tue Jun 03, 2008 11:50 am ] |
| Post subject: | |
No, just wondering. I noticed in my Holley manual that the 1920 is a little bigger than the 1945. So I wondered what other sizes were available from other makers with the same 2 bolt flange. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|