| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Pulley wheel alingment https://www.slantsix.org/forum/viewtopic.php?t=29835 |
Page 1 of 1 |
| Author: | trdrew [ Wed Jul 02, 2008 8:52 am ] |
| Post subject: | Pulley wheel alingment |
Is there normally a spacer that goes between the water pump flange and the pulley wheel that bolts to it? The pulley wheel is too close to the block to line up correctly. |
|
| Author: | AnotherSix [ Wed Jul 02, 2008 9:07 am ] |
| Post subject: | |
No but you can get them. The pump probably has had the flange pressed on too far. |
|
| Author: | Doc [ Wed Jul 02, 2008 9:28 am ] |
| Post subject: | |
Or you may have the wrong water pump pulley or the lower vibration dampener my not be pressed all the way onto the crank. DD |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|