| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Removing a pilot bearing https://www.slantsix.org/forum/viewtopic.php?t=31508 |
Page 1 of 1 |
| Author: | RossKinder [ Sun Oct 05, 2008 6:19 pm ] |
| Post subject: | Removing a pilot bearing |
Any genius tricks out there for getting a bushing out? I got a puller, but it won't do the job. Too short. Thanks |
|
| Author: | Richard Greville [ Wed Oct 08, 2008 8:52 pm ] |
| Post subject: | |
I've been told this works , but have never tried this. Pack the cavity in side the pilot bushing with stiff grease , take care that there is no trapped air. insert a round metal rod the same size as the ID. of the bushing, drive the rod in with a stout blow from a hammer. The idea is the force of the blow will cause the grease to exert hhydrolicpressure , and force the bushing , most of the way out. if you try it let me know if it works , I'm about to change mine. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|