| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Factory stock cylinder head thickness https://www.slantsix.org/forum/viewtopic.php?t=31826 |
Page 1 of 1 |
| Author: | Adrenalin [ Wed Oct 22, 2008 3:49 am ] |
| Post subject: | Factory stock cylinder head thickness |
Dear All, I am about to tear a slant 6 apart for refurbish. Can any one inform me about the original thickness of an Slant 6 cylinder head so that I measure it and understand if its machined or not. Looking forward to your replies... |
|
| Author: | Charrlie_S [ Wed Oct 22, 2008 6:12 am ] |
| Post subject: | |
I measured a bunch of stock heads. They measured from 3.595 to 3.606. This is from the head gasket surface to the valve cover surface. The best way to check is to measure the combustion chamber cc's. |
|
| Author: | Adrenalin [ Wed Oct 22, 2008 11:00 pm ] |
| Post subject: | |
Quote: I measured a bunch of stock heads. They measured from 3.595 to 3.606. This is from the head gasket surface to the valve cover surface. The best way to check is to measure the combustion chamber cc's.
Thank you for your qucik reply, I think this will help.
|
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|