Badly in need of a windage tray. Any leads greatly appreciated.
Thanks Drew

Man,..time's a flyin' I had hoped to be built by now.

MoparBrat63@aol.com

Copying and pasting a msg from further down the thread. I just bought one from Mike. Super nice guy. Gilly

From (dschumer) "Mike was going to be making another run of trays this winter. He may have an extra one laying around. 308-324-3576"

tlg225ccr@aol.com

I spoke with Mike aswell, seems you got the last one. He won't have any made up in time for this spring. I need to keep trying to find a used one.

MoparBrat63@aol.com

<A HREF="http://www.moparchat.com/forums/showthr ... d=45282</A>

This ad appeared on Moparchat a while back.

slantzilla@excite.com

Thanks for the info. I spoke to Dennis at Precision Performance and he needs to know how much clearance there is between stock pan and K-member. Well, my engine has been out for a long time.I never took any measurements.Can anyone help me out by taking some measurements? I supose 63 thru 66 Darts and Vailants should be the same. Please correct me if I'm wrong.
Thanks verymuch. Drew 63GT
P.S. At the rate I'm going,I don't think I will be ready for April.

MoparBrat63@aol.com

I was under my '66 this morning and it appears to me that there is around an inch all the way around the K-frame. If they are going to build off an existing pan, the early A-body pan is different than the later model ones. The sump is farther back, and the back part over the steering linkage may be shallower. Good luck! Dennis

slantzilla@excite.com