| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Porting Template https://www.slantsix.org/forum/viewtopic.php?t=32780 |
Page 1 of 1 |
| Author: | Dizzydean [ Sat Dec 13, 2008 4:00 pm ] |
| Post subject: | Porting Template |
Good Day to all. Is there a place to rent or borrow a template to port the intake/exhaust or somewhere to get some measurements to mark the outside. I have tried asking for a used steel gasket but got no replies-I figured that would work also. Thanks for all the help. |
|
| Author: | Aggressive Ted [ Sat Dec 13, 2008 6:11 pm ] |
| Post subject: | |
You could use a regular FelPro as a pattern. Those are cheap and easy to find. |
|
| Author: | Dizzydean [ Sat Dec 13, 2008 10:47 pm ] |
| Post subject: | |
I didnt think about it but I threw away the old one of the motor I picked up. Darn it!! |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|