Timing chain slack wasn't as bad as I remembers, plus new chain wouldn't fit.
A little lube on the cam
New seals installed
| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Just a few picture of the cam changing https://www.slantsix.org/forum/viewtopic.php?t=34574 |
Page 1 of 1 |
| Author: | Bren67Cuda904 [ Sat Mar 28, 2009 8:01 pm ] |
| Post subject: | Just a few picture of the cam changing |
Timing chain slack wasn't as bad as I remembers, plus new chain wouldn't fit. A little lube on the cam New seals installed
|
|
| Author: | 66aCUDA [ Sun Mar 29, 2009 5:26 am ] |
| Post subject: | |
Brennan Are you changing springs also? Too much pressure? Frank |
|
| Author: | Bren67Cuda904 [ Sun Mar 29, 2009 8:43 am ] |
| Post subject: | |
No. Using the same springs. Just changing out the valve seals. |
|
| Author: | 66aCUDA [ Sun Mar 29, 2009 9:02 am ] |
| Post subject: | |
Yup saw that in another post After I posted here.  Frank 
|
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|