I have 2 different aftermarket versions of the plate.
| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Engine to trans adapter? https://www.slantsix.org/forum/viewtopic.php?t=35681 |
Page 1 of 1 |
| Author: | six popper [ Thu Jun 04, 2009 8:15 am ] |
| Post subject: | Engine to trans adapter? |
I had almost forgoten about this. I purchased a 65 A-100 van sometime back, it had a adapter to put a 727 behind a /6. I was wandering if anyone else had seen one of these. I thought it would be beneficial in being able to put one of the newer 727 based overdrives behind my 225. |
|
| Author: | Joshie225 [ Thu Jun 04, 2009 9:13 am ] |
| Post subject: | |
Yep, had one myself. You can use the adapter to put just about any small block bellhousing behind the slant. I'd use a smaller, lighter A500 before the A518. Dart270 (Lou) has an A500 in one of his cars. |
|
| Author: | slantzilla [ Thu Jun 04, 2009 2:20 pm ] |
| Post subject: | |
I have 2 different aftermarket versions of the plate.
|
|
| Author: | six popper [ Thu Jun 04, 2009 3:58 pm ] |
| Post subject: | |
So if I were to machine the crank spacer for a pilot bearing could I use it to adapt a manual trans. The reason I ask is my truck is a 833 overdrive truck and it would be nice to put a five speed in it. |
|
| Author: | Joshie225 [ Thu Jun 04, 2009 5:45 pm ] |
| Post subject: | |
Sure. Is your hub spacer small register or large? |
|
| Author: | six popper [ Thu Jun 04, 2009 6:15 pm ] |
| Post subject: | |
If I remember correctly it is large. |
|
| Author: | LWS1967 [ Thu Jun 04, 2009 7:48 pm ] |
| Post subject: | |
I've got a 67 A100 with the same setup. It does give you some options, don't know about a manual swap though. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|