| Slant Six Forum https://www.slantsix.org/forum/ |
|
| cast crank build https://www.slantsix.org/forum/viewtopic.php?t=36597 |
Page 1 of 1 |
| Author: | bigdaisy19k [ Mon Aug 03, 2009 11:26 pm ] |
| Post subject: | cast crank build |
has anyone done a build on a cast crank engine? for power? I would like to make some drivable power with my 79 but I need to know what the cast crank rods can take or where to find something that will work. I know that there is a man that goes by buzzin half dozen that supposedly has done some cast engines. any ideas would help. thanks!! |
|
| Author: | Polara1974 [ Tue Aug 04, 2009 4:28 am ] |
| Post subject: | |
In February 2006 Mopar Muscle Issue an article "Leaning(over) kill" about a 300+ HP Slant Six build-up all over a cast crank!!! Look for it on the MM Magazine web. |
|
| Author: | Dart270 [ Thu Aug 06, 2009 6:24 am ] |
| Post subject: | |
Several cast crank hipo motors have been built. I am doing one now. K1 is making billet rods for the cast crank with 198 rod length (7.005"), and they should be done in 2-3 weeks. The 1st 10 sec doorslammer car was Mike Jeffrey in about 1999 with a cast crank motor. He switched back to forged crank when he went over 400 HP on nitrous. Lou |
|
| Author: | Doc [ Thu Aug 06, 2009 8:25 am ] |
| Post subject: | |
I have a super light weight cast crank engine in process but that project has been "slow going". Here is a link to that build-up message thread. DD http://www.slantsix.org/forum/viewtopic ... ght=buster |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|