| Slant Six Forum https://www.slantsix.org/forum/ |
|
| In need of machine shop https://www.slantsix.org/forum/viewtopic.php?t=36611 |
Page 1 of 1 |
| Author: | PsychobillySS [ Wed Aug 05, 2009 10:29 am ] |
| Post subject: | In need of machine shop |
Hi all, new guy here. Kinda. Ive been reading through the site for months but havent needed anythin not already on here. Anyways, Ive decided to do a build on my slant. More questions about that later I'm sure. But for starters, I was wondering if anybody could refer or suggest a reputable, experienced, knowledgeable machine shop in or close to Phoenix, AZ? I lost my garage spc so I'm forced to outsource more than I had intended. Im not building anythin bananas, just doin the typical recommended upgrades. Tryin' to keep the cost from skyrocketin'. Doubt it, but I'll try. Thanks in advance |
|
| Author: | RustyRamcharger [ Thu Aug 06, 2009 10:34 am ] |
| Post subject: | |
There have been some posts with recommendations in the past year. Do a search for keyword "Phoenix". |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|