| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Head width https://www.slantsix.org/forum/viewtopic.php?t=36686 |
Page 1 of 1 |
| Author: | lowbudget [ Tue Aug 11, 2009 7:52 am ] |
| Post subject: | Head width |
Can any body tell how wide a slant head is? I'd just go out to the garage and measure mine but I'm over here in Kuwait at work. I am going to build a set of heads stand over here and need to know that measurement to start planning. That reminds me of a story: When I first started working over here there was a bunch of old stepside long bed trucks just sitting there in the desert. I checked them out and they where all slants. I now wished I would have pilfered them as they got sold to the chinese as scrap about 5 years ago. All I took was an old Kuwaiti license plate. I think they were old Getty work trucks. Thanks in advance Mike |
|
| Author: | 66aCUDA [ Tue Aug 11, 2009 6:47 pm ] |
| Post subject: | |
The Machined surface is 7X26 inches. Thanks for serving and keep your head down, Frank |
|
| Author: | lowbudget [ Tue Aug 11, 2009 8:32 pm ] |
| Post subject: | |
Cool Thank you now I can get them built. Frank to be honest with you I'm not in the service, I've worked in the oilfield over here for 13 years. It pays for my slant habit  I did get to go vist Iraq and kill those fires thou. I love the 28 on 28 off schedule. It gives me time to play as we are not getting any younger. Thanks Again Mike
|
|
| Author: | 66aCUDA [ Wed Aug 12, 2009 5:13 am ] |
| Post subject: | |
[quote="lowbudget" Frank to be honest with you I'm not in the service, I've worked in the oilfield over here for 13 years. e[/quote] Mike at least you get paid better. Still keep your head down. Frank |
|
| Author: | lowbudget [ Thu Aug 13, 2009 9:23 am ] |
| Post subject: | |
Thanks for the info here is a picture of my head stands. They are the best kind of head stands...............FREE!  
|
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|