| Slant Six Forum https://www.slantsix.org/forum/ |
|
| custom pushrods https://www.slantsix.org/forum/viewtopic.php?t=3734 |
Page 1 of 1 |
| Author: | 69 dart [ Fri Jun 07, 2002 7:21 am ] |
| Post subject: | custom pushrods |
I did a search but could not find contact info for a custom pushrod mfg. I remember hearing of one in Bend Oregon I think. Any help ? Thanks |
|
| Author: | DusterIdiot [ Fri Jun 07, 2002 11:02 am ] |
| Post subject: | Re: custom pushrods |
Quote:
: I did a search but could not find contact info : for a custom pushrod mfg. I remember hearing : of one in Bend Oregon I think. Any help ? : : Thanks Smith Brothers try their homepage at <A HREF="http://www.pushrods.net">www.pushrods.net</A> you need to have ALL your measurements or they will just give you the run around. Best thing to do is cut a pushrod, thread and nut it and adjust it to the length you need then send it to them with specs and say "12 of these please" -D.Idiot |
|
| Author: | Matt Cramer [ Fri Jun 07, 2002 4:15 pm ] |
| Post subject: | Re: custom pushrods |
Lots of places make these. I know Comp Cams will make a custom set to your specs. |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|