| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Length of driveshaft... https://www.slantsix.org/forum/viewtopic.php?t=37712 |
Page 1 of 1 |
| Author: | '74 Sport [ Thu Oct 29, 2009 9:49 pm ] |
| Post subject: | Length of driveshaft... |
...for 360 / 727 / 8-3/4" combo in '74 Duster? I need to have one cut down and balanced, so I need to get a good measurement. Once fully seated in the tailshaft, how far should I pull out the front slip yoke to measure the driveshaft's length? Jerry |
|
| Author: | Fopar [ Thu Oct 29, 2009 10:47 pm ] |
| Post subject: | |
My driveshaft builder told me about 1" |
|
| Author: | SlantSixDan [ Thu Oct 29, 2009 11:42 pm ] |
| Post subject: | |
Parts book says this should be a 44.99" (45") driveshaft. Double check and make sure. |
|
| Author: | '74 Sport [ Fri Oct 30, 2009 5:32 am ] |
| Post subject: | |
I'll use both of your bits of information and "reverse engineer" to confirm. And by the way, why couldn't they just say 45"? Seriously, we're talking about a drive shaft, not something like bearing clearance. That 0.01" difference is very small (between 1/128" and 1/64").  Thanks much, Jerry |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|