| Slant Six Forum https://www.slantsix.org/forum/ |
|
| What yoke for a "78" driveshaft https://www.slantsix.org/forum/viewtopic.php?t=37985 |
Page 1 of 1 |
| Author: | flipfloppop [ Mon Nov 16, 2009 7:12 pm ] |
| Post subject: | What yoke for a "78" driveshaft |
Hello, I need some help on a driveshaft yoke for a 1978 Plymouth slant six. I'm putting it in my 1951 International pickup. If any body knows the parts # or what will fit it. I have to get a driveshaft made and I need to know what I'm looking for. Thanks for the help. 
|
|
| Author: | Reed [ Mon Nov 16, 2009 7:23 pm ] |
| Post subject: | |
727, 904, three speed, four speed, etc...? What transmission are you using and what year is the transmission? |
|
| Author: | flipfloppop [ Mon Nov 16, 2009 7:39 pm ] |
| Post subject: | |
Not for sure what automatic transmission it is it came on the "78" plymouth super slant six motor I got to use in my International pickup. Thanks for the reply. |
|
| Author: | DusterIdiot [ Mon Nov 16, 2009 7:50 pm ] |
| Post subject: | Car or Truck motor |
If car, then it's an A-904 and it will use the 25/26 spline yoke with the small u-joints (7260?) If the motor came out of a van or truck it might be either... Best way to tell is to check the tranny pan and see what the shape of the pan is... -D.Idiot |
|
| Author: | flipfloppop [ Mon Nov 16, 2009 8:06 pm ] |
| Post subject: | |
It supposedly came out of a car not a van or truck. Thanks for the information and parts #s. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|