| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Choke wells? https://www.slantsix.org/forum/viewtopic.php?t=38212 |
Page 1 of 1 |
| Author: | Rug_Trucker [ Sat Dec 05, 2009 8:17 am ] |
| Post subject: | Choke wells? |
A friend is being offered a EX manifold. I told him there is 3 different types. He has a '70 Cuda with a 198. I told him to check the casting date maybe we can figure this out. He maybe switching to a 2bbl if it has the intake. |
|
| Author: | SlantSixDan [ Sat Dec 05, 2009 8:46 am ] |
| Post subject: | |
Easiest way to ID the exhaust manifold is visually, with a picture of the choke well. The only type to watch out for is the '70-'72 type with the open choke stove (meant for use with a stainless steel cup and gasket) rather than the cast-in choke pocket. Even the '70-'72 type can be made to work fine by fashioning a blockoff plate or just using the stainless cup and gasket if they're in good condition, and bolting on an Electric choke kit. |
|
| Author: | Rug_Trucker [ Sat Dec 05, 2009 10:14 am ] |
| Post subject: | |
I thought I saw a thread not too long ago. I scanned the last 3 pages of the engine section. Thanks Dan. |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|