You could always wrap duct tape around the plug to make it bigger..................
| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Cam Plug Sizes https://www.slantsix.org/forum/viewtopic.php?t=38348 |
Page 1 of 1 |
| Author: | Greg Ondayko [ Fri Dec 18, 2009 9:25 pm ] |
| Post subject: | Cam Plug Sizes |
I just got the Block Back from the shop for ruster, and i have just got done installing the rear cam bearing and was going to install the ream cam plug too - I have a whole box of 2 9/64's plugs ready to go and Bam! it 's too small. The other blocks I used - 69 - up use the 2 9/64's This is a 64 truck block so it looks like a 2 1/4" cam plug. Is this correct before I go and order one?? Thanks a bunch. Greg |
|
| Author: | emsvitil [ Fri Dec 18, 2009 9:31 pm ] |
| Post subject: | |
You could always wrap duct tape around the plug to make it bigger..................
|
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|