| Slant Six Forum https://www.slantsix.org/forum/ |
|
| flatlander racing https://www.slantsix.org/forum/viewtopic.php?t=39229 |
Page 1 of 1 |
| Author: | akbmotorsports [ Tue Mar 02, 2010 12:52 pm ] |
| Post subject: | flatlander racing |
i was wondering if anyone has purchased from Flatlander Racing? thanks, andy |
|
| Author: | dakight [ Tue Mar 02, 2010 5:07 pm ] |
| Post subject: | |
I bought an engine rebuild kit from them about 4 years ago. It was all name brand stuff, packaged together in a single kit. I got good service from them and the pricing was fair. |
|
| Author: | gmader [ Tue Mar 02, 2010 5:35 pm ] |
| Post subject: | |
Ditto. The kit I got from them seems first rate. |
|
| Author: | akbmotorsports [ Tue Mar 02, 2010 5:42 pm ] |
| Post subject: | |
thanks. they have pretty good pricing on thier site, and have wiseco pistons, isky and schneider cams listed for the slants. |
|
| Author: | 66aCUDA [ Wed Mar 03, 2010 7:00 am ] |
| Post subject: | |
Cam wise you can save LOADS from Erson. Group buy is still on and you can get cam, lifters, springs, retainers and locks on the buy. Just my 02. Frank |
|
| Author: | akbmotorsports [ Wed Mar 03, 2010 9:23 am ] |
| Post subject: | |
thanks. it'll be erson or oregon regrind for my cam. flatlander lists the wiseco protrus about fifty bucks less than direct from wiseco. cheaper is not always better, but in this case it sounds like a good deal. its nice to have some choices for the slant. the good news is i am finally turning some wrenches on this project! thanks for the replies, andy. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|