| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Make Your Own Two Barrel Intake https://www.slantsix.org/forum/viewtopic.php?t=39270 |
Page 1 of 1 |
| Author: | Reed [ Fri Mar 05, 2010 4:52 pm ] |
| Post subject: | Make Your Own Two Barrel Intake |
Better scan of Dave York's seminal article detailing how to turn a one barrel intake into a two barrel intake.   This article discusses how to modify the one barrel throttle linkage and kickdown to mate with the carb (mostly by modifying the carb). I recommend using a lokar/bouchillion cable kickdown and using a cable operated throttle cable. Way easier and lets you use a wider variety of carbs. |
|
| Author: | Wizard [ Fri Mar 05, 2010 6:22 pm ] |
| Post subject: | |
I was thinking of same with my old spare 2.2/2.5 TBI intake. cut the hole and put divider in and use a plate to mount IDF 40 or IDF 44 (going on a 2.2L engine). Just thinking about since 32/36 DFEV is getting me going no where as mixture stops pulling from boosters because air velocity fell low enough under load and limits engine to 3500rpm. Cheers, Wizard |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|