Did they make a Shorty 904? I need one for the FED and think the 727 is too power hungry.
Ideas???
Frank

_________________
Scrapple: Because a mind is a terrible thing to waste.
73 Duster - Race Car
66 Dart Wagon - DD
178" FED
82 D150
All Slant powered

Frank Check with A&A - If they do rick and company will hae the junk to make it go.


http://www.aandatrans.com/


Greg

_________________
http://www.youtube.com/hyperpack

The only short 904 I have ever seen was the one Charles Meyer had built for his RED. He had Moser do a short tailshaft. Last I knew he still had it and would sell it if someone needed it.

Not for sure if any of the trucks used a short 904. I know they used a short 727 in a few of them.

_________________
Official Cookie and Mater Tormentor.

Jeep used 904 with attached transfer case maybe the output shaft from those transmissions could be used with a custom made tail shaft housing could be a solution. :shrug:

_________________
Part of Tyrde-Browne Racing

I dont think it will be hard to have the output shaft cut, resplined and a housing made.
I was more wondering if a piece all ready existed.
If I dont have to reinvent the wheel so to speak....
Thanks,
Frank

_________________
Scrapple: Because a mind is a terrible thing to waste.
73 Duster - Race Car
66 Dart Wagon - DD
178" FED
82 D150
All Slant powered