Did they make a Shorty 904? I need one for the FED and think the 727 is too power hungry.
Ideas???
Frank
| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Shorty 904 https://www.slantsix.org/forum/viewtopic.php?t=39416 |
Page 1 of 1 |
| Author: | 66aCUDA [ Mon Mar 15, 2010 7:38 am ] |
| Post subject: | Shorty 904 |
Did they make a Shorty 904? I need one for the FED and think the 727 is too power hungry. Ideas??? Frank |
|
| Author: | Greg Ondayko [ Mon Mar 15, 2010 12:57 pm ] |
| Post subject: | |
Frank Check with A&A - If they do rick and company will hae the junk to make it go. http://www.aandatrans.com/ Greg |
|
| Author: | slantzilla [ Mon Mar 15, 2010 6:08 pm ] |
| Post subject: | |
The only short 904 I have ever seen was the one Charles Meyer had built for his RED. He had Moser do a short tailshaft. Last I knew he still had it and would sell it if someone needed it. Not for sure if any of the trucks used a short 904. I know they used a short 727 in a few of them. |
|
| Author: | Fopar [ Mon Mar 15, 2010 8:37 pm ] |
| Post subject: | |
Jeep used 904 with attached transfer case maybe the output shaft from those transmissions could be used with a custom made tail shaft housing could be a solution. :shrug: |
|
| Author: | 66aCUDA [ Tue Mar 16, 2010 7:42 am ] |
| Post subject: | |
I dont think it will be hard to have the output shaft cut, resplined and a housing made. I was more wondering if a piece all ready existed. If I dont have to reinvent the wheel so to speak.... Thanks, Frank |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|