Here is the set w spindles I got on CL for $200 + $200 in rebuild parts. New seals, bearings, pads and paint job.
,Cliff
| Slant Six Forum https://www.slantsix.org/forum/ |
|
| My new KH brakes https://www.slantsix.org/forum/viewtopic.php?t=39873 |
Page 1 of 1 |
| Author: | hellion_locdogg [ Sat Apr 17, 2010 4:15 pm ] |
| Post subject: | My new KH brakes |
Here is the set w spindles I got on CL for $200 + $200 in rebuild parts. New seals, bearings, pads and paint job. ,Cliff |
|
| Author: | Pierre [ Sat Apr 17, 2010 8:22 pm ] |
| Post subject: | |
Gonna make your own crossover tubes? |
|
| Author: | ski [ Sat Apr 17, 2010 9:45 pm ] |
| Post subject: | |
Looks good. I'm in the middle of the same swap. ski |
|
| Author: | slantfin [ Sun Apr 18, 2010 6:57 am ] |
| Post subject: | |
I got the nice stainless crossover tubes from Inline Tube. Also splurged on some stainless hold down springs from Mustangs Unlimited, which used the same brakes with different attachment bolts. |
|
| Author: | hellion_locdogg [ Mon Apr 19, 2010 6:31 am ] |
| Post subject: | |
Crossover tubes cleaned up nice. This was just a dry fit, need rh studs for left side. If you notice there are only two lh studs in that pic. Plan on doing the whole rebush of the front end when I do the swap. I already have all the bushings. ,Cliff |
|
| Author: | slantfin [ Mon Apr 19, 2010 12:37 pm ] |
| Post subject: | |
Looks good in orange. |
|
| Author: | hellion_locdogg [ Tue Apr 20, 2010 11:25 am ] |
| Post subject: | |
It's actually Chrystler red engine enamal. Does look orange though. ,Cliff |
|
| Author: | hellion_locdogg [ Mon Apr 26, 2010 3:31 pm ] |
| Post subject: | |
Got them on last week, bled them Thurs. Will post pics w wheels on later. The driver side ball joint was welded in which leads me to believe it was stripped. There was no play so I left it and changed the boot. ,Cliff  
|
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|