| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Intake question https://www.slantsix.org/forum/viewtopic.php?t=40072 |
Page 1 of 1 |
| Author: | 82Stepside [ Mon May 03, 2010 9:05 am ] |
| Post subject: | Intake question |
OK, I've seen the thread asking about which is the best intake to use for fuel injection. And I've read the DiBiase article on batch fire injection using GM electrical stuff. I have on hand a couple of the aluminum 1-barrel intakes - both off 82 Dodge trucks. Would either of these be good for getting the drilling/machining done to install the screw in type injector bungs? Or should I look around for a cast iron intake? Not planning on turbo or anything like that. Just want to improve driveability and pick up some mpg if I can. |
|
| Author: | Sam Powell [ Thu Jun 03, 2010 6:48 am ] |
| Post subject: | |
I am sorry no one with knowledge of these manifolds has spoken up yet. It seems as if a one barrel might be a bit small unless you machine out it for a TB of some kind. I would assume you could machine it for an adapter of some kind, but you would have to make this custom, I think. Also, some of the aluminum Mopar manifolds developed leaks. I don't know if these are among those. Maybe someone with specific knowledge will come forth. I used an Offenhauser manifold, which might be hard to find these days. See if you can get Clifford to respond. I understand they have been little slow lately. Also, look on e-bay and see if you can find an Offy manifold there. SAm |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|