Does anyone know how to make a hose barb using a double flaring tool?
Is there another way?

thanks,

bwhitejr

_________________
'72 Duster (Performance 360)
'83 Ramcharger (Performance 318)
'80 TrailDuster (360)
'80 D-150 Truck (See Below)
CompCams 252S, Holley 390cfm, Offy manifold
Ported, Polished and Gasket Matched
P4286813 Springs,0.040 Overbore,
0.090 Shaved Head

What are you making a hose barb for ??

_________________
Part of Tyrde-Browne Racing

I have a Holley 2280 which has a hard pipe connection on it. I bought a short piece of gas line that has a like connector on each end. I wanted to cut one end of the short piece of line and make a hose barb on it to connect to my rubber gas line.

bwhitejr

_________________
'72 Duster (Performance 360)
'83 Ramcharger (Performance 318)
'80 TrailDuster (360)
'80 D-150 Truck (See Below)
CompCams 252S, Holley 390cfm, Offy manifold
Ported, Polished and Gasket Matched
P4286813 Springs,0.040 Overbore,
0.090 Shaved Head

Just make a flair like you would a brake line, that will hold it no problem.

TopHat

And don't do the 2nd half of the double flaring operation....

_________________
Ed
64 Valiant 225 / 904 / 42:1 manual steering / 9" drum brakes

Yep thats how I do it all the time- just make a 'bubble' at the end so there's no sharp edges to saw through the rubber

_________________

madam im adam