| Slant Six Forum https://www.slantsix.org/forum/ |
|
| ATTN: Andrew Wagner re: Intake Manifold https://www.slantsix.org/forum/viewtopic.php?t=4111 |
Page 1 of 1 |
| Author: | Patrick Devlin [ Mon Sep 02, 2002 3:59 pm ] |
| Post subject: | ATTN: Andrew Wagner re: Intake Manifold |
Andrew, sorry to post here, but I couldn't find your email address. Since I know you do metal fabrication, I was wondering if you could make me an engine flange to be used as the basis for an intake manifold. Please email me to discuss this. I understand if you don't have the time, or if you think the cost would be too high. I'm asking you because I know you've made a home made intake before. My idea is to get a flange in the shape of the intake manifold, then weld on tubes as runners to a log tube for an EFI throttle body. pwd22@drexel.edu |
|
| Author: | andrew wagner [ Tue Sep 03, 2002 7:06 pm ] |
| Post subject: | Re: ATTN: Andrew Wagner re: Intake Manifold |
Go to wagnermotorsports.net and there is a link to my new email. I can help you out on this. sounds cool!! andrew wagner Quote:
:
: Andrew, sorry to post here, but I couldn't find : your email address. : : Since I know you do metal fabrication, I was : wondering if you could make me an engine : flange to be used as the basis for an intake : manifold. : : Please email me to discuss this. I understand : if you don't have the time, or if you think : the cost would be too high. I'm asking you : because I know you've made a home made : intake before. : : My idea is to get a flange in the shape of the : intake manifold, then weld on tubes as : runners to a log tube for an EFI throttle : body. |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|