| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Stupid Engine Bold Question https://www.slantsix.org/forum/viewtopic.php?t=4220 |
Page 1 of 1 |
| Author: | Bob Brady [ Tue Sep 24, 2002 6:35 pm ] |
| Post subject: | Stupid Engine Bold Question |
When I took my pulley/damper off I did not have a retaining bolt to unscrew. My slant six engine book refers to removing a retaining bolt prior to the removal of the damper. Can anyone tell me if I am supposed to have a retaining bolt to screw to the front of the crankshaft where the damper is located. I cannot see how it would work to hold it in place even if I had one. Please advise me with my stupid engine bolt question. lasergame@prodigy.net |
|
| Author: | Bob Brady [ Tue Sep 24, 2002 6:44 pm ] |
| Post subject: | Re: Stupid Engine Bold Question |
Nevermind. I should have read the previous post. lasergame@prodigy.net |
|
| Author: | Doctor Dodge (Doug Dutra) [ Tue Sep 24, 2002 10:14 pm ] |
| Post subject: | Re: The Common SL6 Damper Bolt Question |
Quote:
: Nevermind. I should have read the previous : post. Yes, most all Slants had a "press-on" vibration damper. Some real late engines had a bolt. Nice that all the cranks are tapped with a 3/4-16 thread so you can add a bolt if you want to. (although I have never had a damper come-off the crank, I have had the outer ring come off the damper's hub, now that makes some noise!) DD |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|