| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Handling of O2 sensor. https://www.slantsix.org/forum/viewtopic.php?t=42885 |
Page 1 of 1 |
| Author: | Sam Powell [ Tue Dec 14, 2010 5:13 am ] |
| Post subject: | Handling of O2 sensor. |
When I recalibrate my sensor I wiped the carbon build up off of it. Now it is throwing error codes that Innovate says means I need a new sensor. Was touching the body of the sensor a no-no? Or was this t hing dying anyway? The next question has to do with the brand of sensor if I replace it. Any advice there? Opinions or experience to share? Sam |
|
| Author: | emsvitil [ Tue Dec 14, 2010 3:45 pm ] |
| Post subject: | |
Try the innovate forum, Wiping the carbon shouldn't have done anything unless you used some chemicals. Maybe a WOT run will blast it clean. |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|