Does anyone have any advice on how to change out the motor mounts without taking the engine out? What is a good jacking point to raise the engine? Does the tranny mount need to be loosened? Any advice is welcomed. Thanks

_________________
Ken

65 Dart Convertible Super Sixed

I use a floor jack and a block of wood on the corner of the oil pan and raise the engine, one side at a time, just enough to remove the mount from the bracket and the k-frame. If you think that it may stress the tranny mount, than loosen the bolts on it.

Thanks for the info. I'll give it a try.

_________________
Ken

65 Dart Convertible Super Sixed