| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Any creative ideas to plug distributor hole? https://www.slantsix.org/forum/viewtopic.php?t=43627 |
Page 1 of 1 |
| Author: | 65CrewCabPW [ Sun Feb 13, 2011 1:02 pm ] |
| Post subject: | Any creative ideas to plug distributor hole? |
I'm putting EDIS on my slant and since I don't need the dist sitting down there, i was wondering if anyone had any great ideas for plugging it off without the distributor in place, and sealed to keep dirt / water / etc out? |
|
| Author: | slantzilla [ Sun Feb 13, 2011 1:51 pm ] |
| Post subject: | |
Freeze plug or rubber expansion plug. |
|
| Author: | Reed [ Sun Feb 13, 2011 3:03 pm ] |
| Post subject: | |
You might be able to use a distributor hold down clamp and fashion a flat plate plug to go over/in the hole. Otherwise, ditto on on the rubber expansion plug. |
|
| Author: | 65CrewCabPW [ Sun Feb 13, 2011 6:15 pm ] |
| Post subject: | |
Quote: Freeze plug or rubber expansion plug.
Well, Duuhhh, as Homer would say. Great idea!thanks! |
|
| Author: | 1974duster kev [ Sun Feb 13, 2011 8:38 pm ] |
| Post subject: | |
Weld that bad boy shut! Kev |
|
| Author: | 1980volare [ Mon Feb 14, 2011 2:37 pm ] |
| Post subject: | |
how about a block off plate/ mount for the coil pack? |
|
| Author: | Rick Covalt [ Mon Feb 14, 2011 3:09 pm ] |
| Post subject: | Distributor |
Take a junk points type Distributor housing( Or any that you have laying around) and cut it off and weld a small aluminum plate over the end. Bolt it in with the normal hold down bolt. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|