| Slant Six Forum https://www.slantsix.org/forum/ |
|
| help valve cover https://www.slantsix.org/forum/viewtopic.php?t=43690 |
Page 1 of 1 |
| Author: | 84aspende [ Thu Feb 17, 2011 2:50 pm ] |
| Post subject: | help valve cover |
ok, so today i go to put my vavle cover on my aspen and its all looking good till i got to the lower last three bolts and its the three close to the fire wall, can any one help me? im in de if any one is close by |
|
| Author: | Doc [ Thu Feb 17, 2011 3:27 pm ] |
| Post subject: | |
What is the problem?? I will take a shot... you purchased a "cheap" chrome valve cover and the lower, rear bolt holes do not line up? (just a guess) DD |
|
| Author: | slantzilla [ Thu Feb 17, 2011 3:28 pm ] |
| Post subject: | |
What seems to be the issue? Can't get the bolts in? |
|
| Author: | Fopar [ Thu Feb 17, 2011 4:34 pm ] |
| Post subject: | |
You might try putting the bolts in loosely, after you get them started should be able to move cover around to get them all in place before tightening. Richard |
|
| Author: | 84aspende [ Fri Feb 18, 2011 1:10 pm ] |
| Post subject: | yep |
all of that and yes i tryed the las part |
|
| Author: | SlantSixDan [ Fri Feb 18, 2011 7:01 pm ] |
| Post subject: | |
Those Chinese chrome valve covers are garbage. Wrong bolt holes, no baffles. Pitch it in the trash and put the real one back on. |
|
| Author: | hantayo13 [ Fri Feb 18, 2011 7:14 pm ] |
| Post subject: | |
if you really want/need a chrome vavle cover?????get another used real one and send it to a chome shop keep on roddin' |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|