| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Milling the head? https://www.slantsix.org/forum/viewtopic.php?t=43706 |
Page 1 of 1 |
| Author: | polkat [ Fri Feb 18, 2011 3:53 pm ] |
| Post subject: | Milling the head? |
I have heard that the slant 6 head can be milled up to about .100". Would that be enough to close the chamber on the later heads? ________ Fake weed |
|
| Author: | Doc [ Fri Feb 18, 2011 3:55 pm ] |
| Post subject: | |
No... The flats in the later chamber design are .185 to .200 down from the gasket surface. DD |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|