| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Question about camshaft bushing??? https://www.slantsix.org/forum/viewtopic.php?t=44714 |
Page 1 of 1 |
| Author: | Turbo Toad [ Mon Apr 25, 2011 5:38 am ] |
| Post subject: | Question about camshaft bushing??? |
I was wondering what camshaft degree bushing everybody uses. Do the big block bushings work? Or is there a special /6 version? It's for my turbo build and I'm almost ready to getting the top half of the motor back together. Aaron |
|
| Author: | Dart270 [ Mon Apr 25, 2011 5:40 am ] |
| Post subject: | |
SB chevy bushings work. Can't remember if SB or BB Mopar are the same. Lou |
|
| Author: | Turbo Toad [ Mon Apr 25, 2011 6:23 am ] |
| Post subject: | |
The ones I seen on eBay are for Chevy and Big Block Mopar |
|
| Author: | Shaker223 [ Mon Apr 25, 2011 7:24 am ] |
| Post subject: | |
I used a BB Chrysler bushing. Didn't the SB use a different crank key? |
|
| Author: | Joshie225 [ Mon Apr 25, 2011 9:27 am ] |
| Post subject: | |
SB Chevy/BB Mopar bushing. Small block Chrysler used a Woodruff key on the cam rather than a pin so they made offset keys for those. |
|
| Author: | Greg Ondayko [ Mon Apr 25, 2011 7:15 pm ] |
| Post subject: | |
BB Mopar is the same - That's What I have used. You have to drill the upper sprocket to use it. Greg |
|
| Author: | Turbo Toad [ Mon Apr 25, 2011 8:11 pm ] |
| Post subject: | |
That's what I thought thanks everybody Aaron |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|