| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Exhausting Problem https://www.slantsix.org/forum/viewtopic.php?t=45018 |
Page 1 of 1 |
| Author: | 64 Convert [ Wed May 18, 2011 1:11 pm ] |
| Post subject: | Exhausting Problem |
| Author: | 1974duster kev [ Wed May 18, 2011 1:49 pm ] |
| Post subject: | |
What can these people not weld geez lol to bad your not in FL i'd run an exhaust setup for ya. I did my car and a bunch of friends cars. Kev |
|
| Author: | Joshie225 [ Wed May 18, 2011 1:54 pm ] |
| Post subject: | |
You can always get a full 2 1/4" system from Accurate Ltd. http://www.accurateltd.com/1963-74-225-Slant6_c_71.html |
|
| Author: | Nongan [ Wed May 18, 2011 4:20 pm ] |
| Post subject: | |
I eliminated the multiple bends coming from the head pipe and did one long sweeping bend, I'll get some pictures. I picked up a flange and 2.25" pipe (10') from napa and then I bent in on a hydraulic bender in my schools metal shop. Total cost with the chrome tip was like 60 bucks and time  Also my flange had a beveled inside edge where the pipe fit recessed a little, allowing good weld penetration and easy to fit.
|
|
| Author: | 64 Convert [ Wed May 18, 2011 5:57 pm ] |
| Post subject: | |
Quote: You can always get a full 2 1/4" system from Accurate Ltd.
Sure wish you could order the parts separately, since my muffler and tailpipe are almost new, and already 2" dia.
http://www.accurateltd.com/1963-74-225-Slant6_c_71.html |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|