I disagree with the premise of your question; I think it'd be a pretty interesting plate!
| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Boring plate for slant 6 https://www.slantsix.org/forum/viewtopic.php?t=45917 |
Page 1 of 1 |
| Author: | icepaddles [ Thu Aug 11, 2011 7:51 am ] |
| Post subject: | Boring plate for slant 6 |
Anyone took a 3.5 inch hole saw to make a boring plate out of an old cyl. head? |
|
| Author: | SlantSixDan [ Thu Aug 11, 2011 7:56 am ] |
| Post subject: | |
I disagree with the premise of your question; I think it'd be a pretty interesting plate!
|
|
| Author: | Doc [ Thu Aug 11, 2011 8:51 am ] |
| Post subject: | |
It is easier / faster to cut the top off a scrap engine block. Try to find one that is already bored oversize, then drill-out all the treaded head bolt holes, prior to sawing the deck off.  Or buy / rent a professionally made torque plate. DD 
|
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|