| Slant Six Forum https://www.slantsix.org/forum/ |
|
| DIY flowbench and dyno design plans https://www.slantsix.org/forum/viewtopic.php?t=46901 |
Page 1 of 1 |
| Author: | olafla [ Sun Nov 06, 2011 8:02 pm ] |
| Post subject: | DIY flowbench and dyno design plans |
A very nice DIY flowbench design, a DIY inertia dyno design, design of an accurate ‘tailpipe’ probe for Lambda sensors, a racer's weather station, see my thread in Electrical section Electronic high power, high speed switching relay. Olaf |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|