You nailed it!
http://slantsix.org/forum/viewtopic.php ... ion#295624
Charrlie posted this up a while back.
CJ
| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Unmilled Head Dimension https://www.slantsix.org/forum/viewtopic.php?t=49658 |
Page 1 of 1 |
| Author: | Bruce Pine [ Sat Aug 25, 2012 2:50 pm ] |
| Post subject: | Unmilled Head Dimension |
What is the uncut head dimension from valve cover surface to head gasket surface? 3.600" ?? Are early 60's heads the same dimension as late 60's, 70's and 80's?? I have several heads that have been milled by others. How do I determine, "how much was cut"?? |
|
| Author: | ceej [ Sat Aug 25, 2012 2:58 pm ] |
| Post subject: | |
You nailed it! http://slantsix.org/forum/viewtopic.php ... ion#295624 Charrlie posted this up a while back. CJ |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|