| Slant Six Forum https://www.slantsix.org/forum/ |
|
| 2x2 slant 6 manifold https://www.slantsix.org/forum/viewtopic.php?t=50577 |
Page 1 of 1 |
| Author: | AussieSpeed [ Sun Dec 16, 2012 5:30 am ] |
| Post subject: | 2x2 slant 6 manifold |
We have been looking at a dual 2 barrel intake for the slants,once we can get the long tube early A body headers sorted.. i know they wont be $175.00 we are more expensive but if we start a project no matter how many mountains we need to cross we get it done...we might dangle the carrot when we start a project, but at least we let you eat it... |
|
| Author: | Dart270 [ Sun Dec 16, 2012 8:16 am ] |
| Post subject: | |
Hi Mark, I am guessing you will get a good response to this. Probably good to get someone here to start a "who's in" poll for this before you put a ton of effort in. I hope to have my new 64 Dart motor together by Feb-Mar with your short runner intake on it. Will start with TBI on that and then move to port EFI when I get time. I am betting it will work better overall with the TBI than that same system on the Clifford. Lou |
|
| Author: | Slanted Opinion [ Sun Dec 16, 2012 8:52 am ] |
| Post subject: | |
Long runners, please! |
|
| Author: | wvenable [ Sun Dec 16, 2012 8:54 am ] |
| Post subject: | |
Mark, how would this be different than Offy's 5041? A lot of guys mod these manifolds for 2 -2bbls. I don't know if you saw the dual 2bbl manifold from South Africa? The guy was going to reproduce these but it didn't get off the ground. They had a little bit of a longer runner. Here is a silly idea - how about 3 one bbls? Weber makes one that is about 150 cfm and I think there are others that make new one bbls as well. I just bought an Offy 5041 - so I don't need this type of manifold but THANK YOU for your continued effort to turn out new slant parts! |
|
| Author: | Rug_Trucker [ Sun Dec 16, 2012 3:31 pm ] |
| Post subject: | |
The Profuel 2x2 wouldn't work with A/C. That was the modded Offy 2x1. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|