| Slant Six Forum https://www.slantsix.org/forum/ |
|
| 61 Lancer https://www.slantsix.org/forum/viewtopic.php?t=50901 |
Page 1 of 1 |
| Author: | senginc [ Tue Jan 22, 2013 2:42 pm ] |
| Post subject: | 61 Lancer |
My 61 Lancer is a factory 3 spd, 170 have bad synchros considering using a later 3 spd and later driveshaft to get away from the goofy front ujoints I know where a 69 Dart is with 3spd Does anyone know if I could use the trans and driveshaft (probably need shortened) or would I need to change the rear end also because of the yoke. Would the 69 rear end be the same width? It is still the small bolt pattern I think. Thanks |
|
| Author: | WagonsRcool [ Tue Jan 22, 2013 8:41 pm ] |
| Post subject: | |
AFAIK the rear Ujoint is the same size- therefore the same yoke on the axle (which should be the same width & small bolt pattern as well). Valiants have shorter wheelbase so yep, shorter driveshaft. I don't know if there are any differences in the trans input shaft, clutch disc, etc. |
|
| Author: | Doc [ Wed Jan 23, 2013 8:39 am ] |
| Post subject: | |
What you really want is a "A-230" full syncro 3-speed. These have a side cover, not a top cover. http://www.slantsix.org/articles/4-spee ... -swaps.htm DD |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|