| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Super Six carb bolts https://www.slantsix.org/forum/viewtopic.php?t=50955 |
Page 1 of 1 |
| Author: | duval67 [ Tue Jan 29, 2013 11:10 am ] |
| Post subject: | Super Six carb bolts |
Hey guys, I'm almost through with my super six installation...feeling a little sketchy about the manifolds to head seal but I'll hope for the best. Anyway! I need to know the size of the nuts that hold the carb onto the intake. They are smaller than the nuts my old one barrel used. Thanks for any info guys! |
|
| Author: | DusterIdiot [ Tue Jan 29, 2013 5:51 pm ] |
| Post subject: | 2 of one and 2 of the other... |
Super six uses 2 studs on one end of the carb with 'stepped' nuts (so you can get a wrench on them)...the other two are bolts that are 5/16" (I don't remember if coarse or fine thread though...) Good Luck, -D.Idiot |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|