Don't know what the dimension is, but a 170 is a zero deck height moder anyway I believe.
| Slant Six Forum https://www.slantsix.org/forum/ |
|
| 170 deck height? https://www.slantsix.org/forum/viewtopic.php?t=5236 |
Page 1 of 1 |
| Author: | Matt Cramer [ Sat Mar 15, 2003 6:11 pm ] |
| Post subject: | 170 deck height? |
What is the crank centerline to deck height of a 170 block? After that import piston into slant six thread, I've been thinking of making a spreadsheet that will let me evaluate various combinations of pistons, rods, cranks, and blocks, along with various amounts of milling the head and deck, and I was missing that particular dimension. |
|
| Author: | slantzilla [ Sat Mar 15, 2003 9:40 pm ] |
| Post subject: | |
Don't know what the dimension is, but a 170 is a zero deck height moder anyway I believe.
|
|
| Author: | Matt Cramer [ Mon Mar 17, 2003 7:45 pm ] |
| Post subject: | Thanks! |
That should make it easy to calculate. Come to think of it, the MP Six Cylinder manual lists the piston-to-deck height as 0.040" down in the bore to zero. I'll start with the -0.040" and use that to estimate the block's dimensions. |
|
| Author: | Doctor Dodge [ Mon Mar 17, 2003 7:54 pm ] |
| Post subject: | |
It has been a long time since I built a stock stroke 170 but I think the crank centerline to deck is 9.540 Double check this dim., I don't find anything in my notes to back it up. DD |
|
| Author: | Matt Cramer [ Wed Mar 19, 2003 7:20 pm ] |
| Post subject: | Not quite... |
I double checked that one, Doc. That's a bit too high as that would work out to the pistons sitting way too low in the cylinders. Perhaps you meant 9.054"? |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|