Rear Window Molding

Unanswered topics | Active topics

Home » Board index » Tech Q & A » Other

All times are UTC-08:00

Post new topic Reply to topic

Page 1 of 1

[ 2 posts ]

Print view

Previous topic | Next topic

Author

Message

darwigger

Post subject: Rear Window Molding

PostPosted: Fri Jan 02, 2015 8:28 am

Offline

1 BBL (New)

Joined: Mon Jul 07, 2014 5:39 pm
Posts: 8
Location: Everett, Washington
Car Model:

I have a 74 Dart 4 door sedan. There is a molding clip missing (I'm assuming) that is causing the molding to stick up right at the top where the it joins together. I see the clips for sale all over; my question is, will the rear winshield need to be removed ot install the clip? Is there another way to hold that sucker down?

Thanks!

Top

Profile

Reply with quote

Louise76

Post subject:

PostPosted: Sat Jan 03, 2015 11:56 am

Offline

Turbo Slant 6

Joined: Mon Jan 25, 2010 11:29 pm
Posts: 685
Location: Seattle, WA
Car Model: 75 Dart SE (2),75 Swinger, 74 Dart Sport,91 Ram RV

It is a fight, but I think you can get a clip in place while fighting the rubber molding and goo. I don't remember if the clips there are on a stud (slide sideways to lock on) or screwed on with a short sheet metal screw. An option might be to install the clip an inch to one side of the original by drilling a new pilot hole and using a screw.

_________________
"Louise", a 1976 Dart Custom project, (now sadly reverted to being just an "organ donor" to our other project Darts.)