| Slant Six Forum https://www.slantsix.org/forum/ |
|
| What Do These Fit? https://www.slantsix.org/forum/viewtopic.php?t=57075 |
Page 1 of 1 |
| Author: | 65 dartman [ Tue Feb 10, 2015 5:16 pm ] |
| Post subject: | What Do These Fit? |
Anyone recognize these headers? They are 6 into 1 and believe they are Hookers with a measured 3 inch collector. I thought I read someplace the early Hookers had a 3 inch collector while the later 6 into 1's had a 2 and 1/2 inch collector. So, best guess, do they fit early 63-66 A's? I would think they'd fit the 67-76 chassis no problem. Or are they maybe for a truck? 
|
|
| Author: | Rick Covalt [ Tue Feb 10, 2015 6:32 pm ] |
| Post subject: | |
Is there a 4 digit number stamped on the flanges anywhere? I doubt they fit an early A-body. Definitely not a M/T one. Rick |
|
| Author: | se7enine [ Tue Feb 10, 2015 6:58 pm ] |
| Post subject: | |
Don't most of the truck headers have the pipes collect towards the center and then slope towards the back? |
|
| Author: | spacecommander [ Tue Feb 10, 2015 10:34 pm ] |
| Post subject: | |
Quote: Don't most of the truck headers have the pipes collect towards the center and then slope towards the back?
Or collect at the center and go straight down - my 1982 W150 needs those as it has a huge geared starter mounted in the low position. I love these Hooker headers with the manifold heat but they are $650 - don't have that kind of cash.
|
|
| Author: | 65 dartman [ Wed Feb 11, 2015 8:43 am ] |
| Post subject: | |
Quote: Is there a 4 digit number stamped on the flanges anywhere?
Yes to a number on the flange - it's 9471 plus the flanges are no where 1/2 in thick - probably 3/8th with some kind of spacer welded where needed to the flange in order to bolt to the block. Maybe that number will show up if someone has an old Hooker (or whoever made them) parts book.
Rick |
|
| Author: | drgonzo [ Wed Feb 11, 2015 10:42 am ] |
| Post subject: | |
I pulled a very rusty set from a 71 Valiant that looked just like those. |
|
| Author: | se7enine [ Wed Feb 11, 2015 12:16 pm ] |
| Post subject: | |
On another thread here they were thought to be 6X1 JR/Mopar Perf headers that require some banging to fit early A. http://www.slantsix.org/forum/viewtopic ... de770ae75e |
|
| Author: | se7enine [ Wed Feb 11, 2015 12:20 pm ] |
| Post subject: | |
If you end up selling let me know, they will fit my 67 barracuda. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|